Use an adjustable wrench to loosen the nuts on the bolts.Look for the toilet bolts on each side of the toilet bowl.This braided line is connected from the shut-off valve to the toilet tank. Otherwise, it will spill all over your bathroom when you remove the toilet. It is important to remove this water now. Use the same sponge to remove the water at the bottom of the toilet bowl.Use a sponge to soak it and squeeze it into the bucket. At the bottom of the toilet tank, there is some water left.Remove the toilet tank lid and place it safely where it cannot crack.Flush the toilet and hold the flush handle down to remove as much water as possible.If you have the push/pull type of valve, pull the handle out. ![]() Locate the toilet shut-off valve on the rear wall of the toilet and turn it clockwise.Replacing toilet bolts involves the following 6 steps: Step 1: Turn off the Water on the Toilet This is a safer option, especially if you are working alone. For a two-piece toilet, on the other hand, you can decide to remove the tank the then bowl later. While removing the one-piece toilet, you have no alternative but to remove it in one go. One-piece toilets have the tank and the bowl made as one body, while in a two-piece toilet, the bowl and the tank are two pieces joined together with bolts. Your toilet will either be a one-piece toilet or a two-piece toilet. Sometimes the toilet bowls are covered using color-matched plastic caps. Replace the bolts and the wax ring, then install the toilet back. Rock the toilet, lift it off, and lay it on its side. Loosen the bolt nuts with a wrench or cut them off if they are corroded. To replace a toilet mounting bolts, you will first need to turn off the water to the toilet, then drain the tank and the bowl. This is an inexpensive repair, and you can comfortably do it on your own. In this case, you will need to replace the toilet bolts. This helps to strongly anchor the toilet on the floor and compress the wax ring between the flange and the bottom of the toilet to create a watertight and airtight seal.Īfter a period of time, toilet bolts become corroded or loose and cannot anchor the toilet bowl like before, making it start wobbling/rocking. ![]() Toilet bolts are hooked on the toilet flange and tightened around the base of the toilet bowl using nuts and washers. Depending on your toilet, toilet bolts are installed 10, 12, or 14 inches from the rear finished wall of the toilet. Toilet anchor bolts are the two bolts on each side of the toilet bowl used to secure the toilet to the floor. Last Updated on Jby toilethaven What are toilet anchor bolts?
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |